53 Great North Road, Winton, New Zealand. Ph 03 236 6077 Fax 03 236 6088

(A)  3 RING CATTLE FEEDER

Manufactured from either 20mm or 25mm Dia pipe. Economy feeder for dairy cattle where the balage will be eaten in a short space of time. Standard feeder has 4 upright legs but can also be manufactured with 6 or 8 legs.

 
(B)  3 RING CATTLE or DEER FEEDER

Manufactured from either 20mm or 25mm Dia pipe. Same as feeder A but with mesh around the lower half. This eliminates balage falling down and out the lower spacing and significantly reduces wastage. Available from 20mm or 25mm pipe.

(C) 27 BAR SHEEP FEEDER

27 Bar sheep feeder for ewes or hoggets. Diameter reduced to 1.6m to allow sheep access to centre of bale.

(D) 27 BAR & MESH Ideal for ewes, hoggets and weaner deer.  Similar to above but with the mesh around bottom reduces balage being pulled from the bale falling out beyond the bars and then being stepped on and wasted. Also doubles as an excellent lamb mothering up pen while still allowing ewe access to grass.

(E) 5 RING SHEEP WITH MESH Similar to D but with 2 extra horizontal rings in place of the vertical bars. This reduces manufacturing materials and time resulting in a lower cost to D above. Also doubles as a lamb mothering up pen and with daily shifting gives ewe access to fresh grass.

(F) CRADLE FEEDER

Used for sheep and cattle. Can be used with hay or balage and up to 5 foot diameter bales. Standard size 1.6m Diameter and 1.5m long. Other sizes made to order. Also available with towing eye and shorter legs for sheep only use.

Key features of all Winton Stock Feeders

• Fully Galvanized construction
• All pipe joins full weld for maximum strength & durability
• Maximum efficiency when correct feeder selected for the stock type

Pricing excluding GST